Filter
Top Products
29
REMOTE CONTROL
The terminal on the DTR-6.3/5.3 is for connecting other Integra/
Onkyo components equipped with the same
terminal. When a
component is connected to the
terminal, it can be operated by the
remote controller supplied with the DTR-6.3/5.3. In addition, when
you connect a component to the
terminal, you can also perform
the system operations given below.
Power on/ready function
When the DTR-6.3/5.3 is in the standby state, if an -connected
component is turned on, the DTR-6.3/5.3 also turns on and the input
source selected at the DTR-6.3/5.3 automatically switches to that
component.
Be aware that this function will not work if the power cord for the
-connected component is connected to the AC OUTLET on the
DTR-6.3/5.3, or if the DTR-6.3/5.3 has already been turned on.
Direct change function
When the play button is pressed at an
-connected component, the
input source selected at the DTR-6.3/5.3 automatically changes to that
component.
Power off function
When the DTR-6.3/5.3 is placed in the standby state, all -
connected components are also automatically put into the standby
state.
Also, if you press the On button on the DTR-6.3/5.3 remote
controller while the DTR-6.3/5.3 is turned on, all
-connected
components (DVD players, CD players, MD recorders, tuners, etc.)
are also turned on.
Caution:
If an MD recorder is connected to the TAPE jack on the DTR-6.3/
5.3, switch the Input Selector from TAPE to MD (see page 45).
DTR-6.3/5.3
REMOTE
CONTROL
Ex: Integra/Onkyo CD
player
connector
Ex: Onkyo cassette tape
deck
connector
Connections (DTR-6.3/5.3)
To connect components using the terminal, simply connect a
remote control cable from this
terminal to the terminal of the
other component. An remote control cable with a 1/8-inch (3.5-
mm) miniature two-conductor plug comes with every cassette tape
deck, compact disc player, MD recorder, and DVD player that has an
terminal.
• When performing operations with -connected components
using the system, do not use the remote zone (Zone 2) (DTR-
6.3 only).
• For remote control operation, the audio connection cables must
also be connected.
• If a component has two
terminals, you can use either one to
connect to the DTR-6.3/5.3. The other one can be used to daisy
chain with another component.
• With Integra/Onkyo DVD players, you can enter the pre-
program code so that you can operate the DVD player directly
with the remote controller without connecting the
terminals
(see page 66).