Filter
Top Products
23
Standby/On
Standby
Power
On
O
f
f
Phones
DVD
Video 2
Video 1
Video 3
Bass
Treble
Master Volume
Smart
Scan
Navigator
DimmerDisplay
Tuning
FM ModePreset Memory
Preset
VCR
Audio
Selector
Tape FM AM Phono CD
Push To Enter
DSP/Mode ADJ
Setup
Return
CH Level
ABSpeakers
FM Mode
AMFM
Tuning /
Listening to Radio Broadcasts
One of the features of the DTR-5.2 that is most frequently used is its
ability to play FM and AM broadcast radio stations. The DTR-5.2
provides a number of listening modes perfect for listening to the
radio and getting the most out of your audio system. Also, by
presetting radio stations that you listen to frequently, you can select
them easily by pressing the CH
button on the remote controller.
Tuning into a radio station
1. Press either the AM or FM input
source button.
2. Using the Tuning and buttons
on the front panel, tune into the
station you desire.
• The tuner frequency changes in 50 kHz increments for FM
and 10 kHz increments for AM.
• When tuning into FM stations, you can press the Tuning
or
button continuously for more than 0.5 seconds to scan for
an FM station in the direction of the button you pressed (FM
auto tuning mode). After you release the button and a station
is received in stereo, the scanning stops.
TUNED
FM STEREO
FM MUTE
Tuned in stereo
Band Frequency
FM MUTE
“FM STEREO”
(Lights red)
Listening to a stereo radio station (FM mode)
When you tune into a radio station, TUNED
indicator appears in the display. If you tune into
an FM station in stereo, then “FM STEREO”
appears. If the signal is weak, it may be
impossible to tune into the station in stereo. In
such a case, press the FM Mode button on the
front panel. The FM MUTE indicator turns off.
At this time, the station will be in mono and
interstation noise will be heard.
FM
Mode