Epson MovieMate 30s Home Theater System User Manual


 
Specifications and Notices 69
If you use the projector in a country other than where you purchased it, use the correct power cord
for that country.
Place the projector near a wall outlet where the plug can be easily unplugged.
Don’t place the projector where the cord can be walked on. This may result in fraying or damage
to the plug.
Don’t insert the plug into an outlet with dust present, and insert the plug firmly into the outlet.
Failure to do so could result in sparks or fire.
Don’t handle the plug with wet hands.
Don’t overload wall outlets, extension cords, or integral convenience receptacles. This can cause
fire or electric shock.
Unplug the projector from the wall outlet and refer servicing to qualified service personnel under
the following conditions: when the power cord or plug is damaged or frayed; if liquid has been
spilled into the projector, or if it has been exposed to rain, water, or excessive humidity; if it
doesn’t operate normally when you follow the operating instructions, or if it exhibits a distinct
change in performance, indicating a need for service; if it has been dropped or the housing has
been damaged.
If there is an electrical storm, do not touch the power plug, otherwise you may receive an electric
shock.
Keep the projector unplugged when not in use for extended periods.
Keep the batteries for the remote control out of the reach of children. Batteries are choking hazards
and can be very dangerous if swallowed. If they are swallowed, seek medical attention immediately.
Replace the batteries as soon as they run out.
Do not expose batteries to heat or flame.
Dispose of used batteries according to local regulations.
Remove the batteries if you won’t be using the projector for a long period of time.
Don’t block the slots and openings in the projector case. They provide ventilation and prevent the
projector from overheating. Don’t operate the projector on a sofa, rug, or other soft surface, or in a
closed-in cabinet unless proper ventilation is provided.
Material or paper may get stuck against the air filter underneath the projector while it is in use.
Remove anything from underneath the projector that might get stuck against the air filter in this
way.
Don’t place the projector or remote control on top of heat-producing equipment or in a heated
place, such as a car.
Don’t use the projector outside of the required temperature range (see page 64). Doing so may
cause an unstable display and could lead to projector damage.
Don’t store the projector outside of the required temperature range (see page 64) or in direct
sunlight for long periods of time. Doing so may cause damage to the case.
Make sure there is at least 8 inches of space between the exhaust ventilation slots and the wall or
other object.