Filter
Top Products
Mounting
Rotate the user interface on the electronics module (optional)
The user interface on the transmitter electronics module can be rotated 180° from the original position.
Procedure
1. Shut off power to the unit.
2. Unscrew and remove the transmitter housing cover.
If the transmitter is installed in a hazardous area, be sure you have shut off power to the transmitter
before removing the housing cover. Removing the transmitter housing cover in a hazardous area while the
transmitter is powered up can cause an explosion.
3. Remove the user interface:
a. Loosen the two user interface screws.
b. Gently lift the user interface, disengaging it from the connectors on the electronics module.
4. Rotate the user interface to the desired position and plug it into the user interface connectors on the electronics
module.
5. Tighten the user interface screws.
6. Replace and tighten the transmitter housing cover.
7. Restore power to the transmitter.
InstallationManual
7