Filter
Top Products
86
About optional equipment
Other operations
Connecting portable audio
players to the AUX jack
Use an accessory cord commonly available. With
the RCA connector to connect a portable audio
players and other external inputs can be
connected to the system.
There are 2 connection terminals on this main
unit; one for RCA connector and the other for
optional LAN cable (AUX 105).
Activation of the AUX mode will light
the "AUX" indicator and channel
audio player output to the system
speakers.
Each time the button is pressed, the
mode will switch as follows:
AUX1(Input) ↔ AUX1(Sub Input)
ATTENTION
• While the AUX mode is activated, actions
such as turning off the audio player or pulling
out the connection cord may cause noise
spikes that can damage the system speakers.
Be sure to avoid this possibility by turning off
system power or switching from the AUX
mode to another mode before shutting off or
disconnecting the portable audio player.
• Audio output levels will differ for the various
devices that can be connected by this
method. Carefully adjust volume until the
output level of the connected player is known.
• Before using a portable audio player in a
vehicle, read the player's operation manual
carefully and confirm problem-free operation
in the vehicle before proceeding.
Changing auxiliary input sensitivity
The sensitivity of the auxiliary mode can be
changed.
The function mode is activated.
Only in the AUX mode.
The AUX sensitivity mode is
activated.
Turning the button allows you to
toggle through sensitivity modes as
follows:
Low ➔ Mid ➔ Hi ➔ Lowwww
ATTENTION
Input sensitivity modes are roughly as follows:
Low 1 Vrms
Mid 480 mVrms
Hi 240 mVrms
The selected settings will take effect.
At this time, other adjustments can
also be mode in function mode.
1
Turn on the portable audio player
and start its play function.
2
Switch to AUX mode by pressing
the [DISC] button for more than
one second.
3
Press the button [3] to switch the
AUX mode.
1
Press the [FUNC] button.
2
Turn the [SEL] button to select
AUX Sensitivity.
3
Press the [SEL] button.
4
Turn the [SEL] button to select the
sensitivity mode.
5
Press the [SEL] button.
6
Press the [RTN] button.
7
Press the [FUNC] or [RTN] button
to exit function mode.