Filter
Top Products
38
Various Settings
How to operate the ESN
(Memory Stick) security
How to record a security code
A [SEC] message appears, in two
seconds it will change to [MS].
ATTENTION
• If a Memory Stick has already been
inserted, a [MS EJECT] message appears.
In this case, eject the Memory Stick and
insert again. (Refer to "Ejecting the Memory
Stick" on page 27 for details of ejection of
the Memory Stick.)
• If the security is already activated,
recording the security code function is not
available.
A [- - - -] (security code input display)
appears.
(Refer to "Listening to MG Memory
Stick" on page 25 for details on
insertion of the Memory Stick.)
Enter a four-digit security code using
digits 0 to 9, A to F. The number
(shown on the display) changes in
ascending order between 0 and 9, A
and F each time the button is pressed.
Each button number (1 to 4)
corresponds to each digit (first to
fourth) of the security code.
The security code is registered in the
main unit and security is set.
The registered security code is
encrypted and then written to the
Memory Stick.
ATTENTION
When the security code is registered using
a Memory Stick that contains several kinds
of data, such as music, etc., be careful not
to clear the recorded data by formatting the
Memory Stick.
Refer to "Ejecting the Memory Stick"
on page 27.
How to cancel the Memory Stick
security
The security function can be canceled when the
security code that has been recorded with the
main unit is entered and verified.
Canceling the security function can be done by
entering the security code into the main unit, or
by using the Memory Stick.
Cancelling the security function by
entering the security code
A [SEC] message appears, then in two
seconds it will change to [- - - -]
(Security code input display).
1
Check that the main unit is in
standby.
2
Press and hold the button [1], then
the [FUNC] button, and hold both
for more than one second.
3
Insert the Memory Stick into the
slot and close the front panel.
4
Input a security code by pressing
the buttons [1] to [4].
5
Press the [FUNC] button for
more than one second.
6
Eject the Memory Stick.
1
Check that the main unit is in
standby.
2
Press and hold the button [1], then
the [FUNC] button, and hold both
for more than one second.