Filter
Top Products
HD Receiver’s Menu System
Page 7-7
16:9 image. No image content is lost, but the horizontal and vertical resolution is
reduced.
Note: If you are using a 4:3 television or monitor and receiving a 4:3 image,
the Image Shape setting will have no effect.
If you are using a 16:9 television or monitor and receiving a 4:3 image, which is narrower than
the screen, you can choose between two different display methods:
Full
In the full mode, 4:3 images will be compressed vertically and enlarged horizontally to
fill the screen with the entire image. No image content is lost; however, images will
appear short and wider than normal.
Note: To minimize the chance of uneven picture tube aging, the cropped or full
mode is recommended.
Cropped
The 4:3 image is enlarged to fill the screen horizontally and centered vertically. Some
image content is lost at the top and bottom of the 4:3 image.
Note: To minimize uneven picture tube aging, the cropped mode is
recommended.
Side Panels
The 4:3 image fills the screen vertically and is centered horizontally. You will see gray
bars on the left and right of the 4:3 image. No image content is lost, but the horizontal
resolution is reduced.
Note: If you are using a 16:9 television or monitor and receiving a 16:9 image,
the Image Shape setting will have no effect.
Limits
Highlighting the Limits button on the SETUP screen
and pressing the key on the remote control will
display the LIMITS screen shown. The LIMITS
screen provides settings to help you control the
viewing restrictions on satellite programming. These
limits, when accompanied by the CHANNEL LISTS,
put TV-watching control in your hands.
Note: The TV Timer, Rating, and
Spending Limits are in effect only
when the HD receiver is locked.
Locking and unlocking the HD
receiver is explained later in this chapter.
On the left of the LIMITS screen are buttons for Done, Video, TV Timer, Rating Help, and Max
Spending, which are explained below.
Done
Highlighting the Done button on the screen and pressing the key on the remote control
will cause an exit from the LIMITS screen and a return to the SETUP screen.
The LIMITS screen
SELECT
SELECT