Filter
Top Products
0
Getting Started Connections Setup Playback Information Troubleshooting
ENGLISH
Remote Control Unit Operations
1
Set [SOURCE CONTROL] to the component to be
registered.
2
Press [AUDIO/RDS] and [ZOOM/RT] at the same
time.
The indicator starts flashing.
3
Referring to the included list of preset codes (vEnd
of this manual), press [NUMBER] (0 ~ 9) to input the
preset code (a 3-digit number) for the manufacturer
of the component whose signals you want to store in
the memory.
4
To store the codes of another component in the
memory, repeat steps 2 to 3.
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
[SOURCE
CONTROL]
[TV INPUT]
[REPEAT]
[CALL]
[AUDIO/RDS]
[ZOOM/RT]
[NUMBER]
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit’s transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• Operation is not possible for some models.
Operating a component stored in the
preset memory
1
Set [SOURCE CONTROL] to the component you want
to operate.
2
Operate the component.
b For details, refer to the component’s operating instructions.
b Some models cannot be operated with this remote control unit.
Setting the preset memory function
DENON and other makers of components can be operated
by setting the preset memory.
This remote control unit can be used to operate components
of other manufacturers without using the learning function
by registering the manufacturer of the component as
shown in the list of preset codes ( End of this manual).
1
Set [SOURCE CONTROL] to the component to be
registered (DVD / CD / FM/AM / iPod NET/USB).
2
Press [CALL] and [REPEAT] at the same time.
The indicator starts flashing.
3
Input the number of the component you want to set.
Number
TV 1
SAT/CABLE 2
VCR 3
No setting 0
Setting the punch through function
“Punch Through” is a function allowing you to operate
[SOURCE CONTROL] and [TV INPUT] on “TV”, “SAT/CABLE”
or “VCR” components when in the “DVD / CD / FM/AM /
iPod NET/USB” mode. By default, nothing is set.
Signal transmission
indicator
Remote Control
1.S-302E3_1st.indd 44 2007/07/31 17:45:11