Filter
Top Products
Getting Started Connections Setup Remote Control Information Troubleshooting
ENGLISH
<FUNCTION> <+/–>
ON/STANDBY
1
[ENTER]
[TUNING +/–]
[CHANNEL +/–]
1
[RETURN]
[DVD/CD],
[FM/AM], [AUX],
[iPod], [NET/USB]
[DISPLAY]
[
uio p
]
[NUMBER]
[CALL]
[MEMO]
[ENTER]
[RETURN]
[
uio p
]
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Playback
To only preset
q Press [MEMO] while the broadcast station is tuned in.
w Select the number using [ui], then press [ENTER].
Or use [NUMBER] (0 ~ 9, +10) to select the number.
NOTE
If a station is preset at a number that has already been preset, the old
settings are deleted and replaced with the new settings.
Automatically Presetting FM Stations
(Auto preset)
Up to 60 stations can be preset.
1
Use <FUNCTION> or [FM/AM] to select “TUNER”.
:
”TUNER” (vpage 17)
2
Press and hold in <1>.
“AUTO PRESET?” and “–:NO/+:START” are displayed alternately.
b Press <–> to cancel auto presetting.
3
Press <+>.
“SEARCH” flashes, then “COMPLETED” is displayed.
• Broadcast stations whose antenna signal are weak cannot be preset
automatically. If you wish to preset such stations, tune them in
manually.
• Once auto presetting starts, it cannot be canceled (it takes about 60
seconds to be completed).
Listening to Preset Stations
To stop the auto tuning
Press <+/–>, [TUNING +/–] or [o p].
Manual tuning
The reception frequency changes each time <+/–>, [TUNING +/–] or
[o p] is pressed.
Naming the Currently Tuned in Broadcast
Station and Presetting it
Up to 60 stations (total for AM and FM) can be preset.
Names of up to 8 characters can be input.
1
Tune in the broadcast station
2
Press [MEMO] twice.
The name input mode is set.
3
Use [ui] to select the character , then press
[ENTER].
b Characters that can be input.
A to Z, 0 to 9 + [CALL] for small letters
! “ # $ % & ’ ( ) * + , - . / : ; < = > ? @ [ \ ] ˆ _ { ¦ } (space)
b Press [o p] to move the cursor.
Use this to correct input characters.
b To cancel character input, press [MEMO].
Everything that has been input is canceled.
4
Once you are nished inputting, press [ENTER].
“P0 –” flashes on the preset number display.
5
Use [ui] to select the number, then press [ENTER].
Or use [NUMBER] (0 ~ 9, +10) to select the number.
The preset number, reception band and reception frequency are
displayed, then the name of the broadcast station appears.
Changing the broadcast station name
q Call out the preset name you want to change, then press [MEMO]
twice.
w Perform steps 3 and 4 at “Naming the currently tuned in broadcast
station and presetting it”.
Use <+/–>, [CHANNEL] or [NUMBER] (0 ~ 9, +10) to select
the preset number.
b Operate <+/–> after switching to the preset mode (vpage 315).
1.S-302E3_1st.indd 36 2007/07/31 17:45:02