Filter
Top Products
Setup Playback Remote Control Information Troubleshooting
ENGLISH
Audio cables Video cables
Coaxial digital connections
(Orange)
Coaxial digital (75Ω / ohms pin-plug) cable
Optical digital connections
Optical transmission cable
Analog connections (stereo)
(White)
(Red)
R
L
R
L
Stereo pin-plug cable
Network connections (wired LAN)
LAN cable
Component video connections
(Green)
(Blue)
(Red)
(Y)
(PB/CB)
(PR/CR)
Component video cable
S-Video connections
S-Video cable
Video connections
(Yellow)
75Ω / ohms pin-plug video cable
Audio and video cables
HDMI connections
19-pin HDMI cable
Signal direction
Audio signal: Video signal:
Output
Input
Input
Output
Output
Input
Input
Output
NOTE
• Do not plug in the power supply cord until all connections have been
completed.
• When making connections, also refer to the owner’s manual of the
other components.
• Be sure to connect the left and right channels properly (left with left,
right with right).
• Do not bundle power supply cords together with connection cables.
Doing so can result in humming or noise.
Select the cables according to the equipment being connected.
Connections
Connections for all compatible audio and video signal formats are
described in these operating instructions. Please select the types
of connections suited for the equipment you are connecting.
With some types of connections, certain settings must be made
on the S-302. For details, refer to the instructions for the respective
connection items below.
Preparations
Cables Used for Connections
To change the speaker cable
Refer to the procedure below if you want to switch to a different
speaker cable. This example describes how to mount the “+” side
cable to the connector. Mount the “–“ side cable in the same way.
1
Insert the included hexagonal wrench into the hole at
the side of the connector’s “+” side. (Arrow A)
2
Turn the hexagonal wrench in the direction of arrow
B to loosen the cable.
3
Pull out the old cable. (Arrow C)
b Be careful not to leave any broken wire parts inside the
connector.
4
Peel off the cable’s sheath and insert the new cable .
(Arrow D)
5
Turn the hexagonal wrench in the direction of Arrow
E and tighten securely so that the cable cannot be
pulled out.
b If the polarities are inverted, the phase
may be off and the bass sound may
be missing, resulting in an unnatural
sound.
C
D
A
E
B
Getting Started Connections
1.S-302E3_1st.indd 13 2007/07/31 17:44:31