Filter
Top Products
94
n Steps for setting “Amp Assign”
This unit is provided with ten types of Assign Mode settings.
You can switch the channels assigned to a power amplifier in accordance with your speaker system or perform playback using up to 11
channels using a combination of the built-in power amplifier for 9-channel and an external power amplifier for 2-channel. You can also use
this unit as a preamplifier.
Use the following flowchart to set the speaker system of this unit.
“Assign Mode” settings
Select the method for using a power amplifier in accordance with your
speaker system (vpage95 – [1]).
NORMAL ZONE2
Z2/3-
MONO
Bi-AMP 2CH Front B
2CH Bi-
AMP
ZONE2/3 11CH
PRE
AMP
“Assign Sp.” settings
Select the speaker terminal from which to output the signals
assigned to the power amplifier (vpage95 – [2]).
“Ext. Amp”
settings
Select a channel that
uses the PRE OUT
connector (vpage95
– [3]).
“Assign Sp.”
settings
Set whether or not
to use the speaker
terminals for multizone
(vpage95 – [4]).
S.BACK F.HEIGHT F.WIDE Height Front None ZONE2/3
9.2ch
(5.2 + SB + FH)
(5.2 + SB + FW)
7.2ch
(5.2 + FH)
(5.2 + FW)
7.2ch
(5.2 + SB)
(5.2 + FW)
7.2ch
(5.2 + SB)
(5.2 + FH)
7.2ch
(5.2 + SB)
5.2ch
11.2ch
(9.2 + Height
(PRE OUT))
11.2ch
(PRE OUT)
Maximum number of channels that can be used for the MAIN ZONE audio
11.2ch
(9.2 + Front
(PRE OUT))
MANUAL SETUP
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
1.AVR4311CIEU_ENG_108.indd 94 2010/08/30 20:11:07