Denon AVR-4311CI Stereo Receiver User Manual


 
62
Connect
For speaker impedance and speaker cable connections, see page 5.
PRE AMP mode
You can connect all speakers to an external power amplifier and use
this unit as a preamplifier.
Using this unit as a preamplifier, you can perform up to 11.2-channel
playback.
When the PRE AMP mode is used, the built-in power amplifier
operation of this unit is stopped, and interference to the preamplifier
from the power amplifier can be reduced.
To use this unit as a preamplifier, select “Amp Assign” and set
“Assign Mode” to “PRE AMP” using steps 3 and 4 of “Set up “Amp
Assign”” (vpage63).
• When the PRE AMP mode is used, the MAIN ZONE audio is not
output from the speaker terminals of this unit.
To use the speakers for multizone (ZONE2/ZONE3) in the PRE AMP
mode, set “Amp Assign” – “Assign Sp.” to “ZONE2/3” (vpage95).
This setting will output the ZONE2 audio from the surround back
speaker terminals and ZONE3 audio from the front wide speaker
terminals.
• For connecting power amplifier and speaker systems, refer to the
instruction manual supplied with the power amplifier to be used.
FL
FR
C
SBL SBR
SL
SR
FWR
FWL
FHR
FHL
SW1 SW2
Power amplifier
1.AVR4311CIEU_ENG_108.indd 62 2010/08/30 20:10:53