Denon AVP-A1HD Stereo Amplifier User Manual


 
0
Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpecificationsSetup
d Source Delete
AVC-A1HD
g Source Delete
AVP-A1HD
Remove input sources that are not used from the display.
[Selectable items]
ON
Delete
NOTE
• Input sources being used in the various zones cannot be deleted.
• Input sources set to “Delete” cannot be selected from GUI menu
“Source Select” or using the SOURCE SELECT knob on the main unit
or SOURCE SELECT button on the remote control unit.
s Volume Control
AVC-A1HD
f Volume Control
AVP-A1HD
Set the MAIN ZONE volume setting.
Volume Limit
Make a setting for maximum volume.
[Selectable items]
OFF
–20dB
–10dB
0dB
Power On Level
This sets the volume set when the MAIN ZONE’s power is turned on.
[Selectable items]
Last
– – –dB
–80dB ~ 18dB
Mute Level
This sets the amount of attenuation of the volume when the mute
mode is set in the MAIN ZONE.
[Selectable items]
Full
–40dB
–20dB
s XLR Out Polarity
AVP-A1HD
Set to switch the XLR pre-out terminal polarity.
d POA Setting
AVP-A1HD
Set when connecting the receiver to a POA-A1HD.
POA LINK
Set when connecting the receiver to a POA-A1HD through a CONTROL
LINK.
[Selectable items]
OFF
ON (Single)
ON (Dual)
[Selectable channels]
Front L
Front R
Center
Surround L
Surround R
Surround Back L
Surround Back R
Front Height L
Front Height R
Front Wide L
Front Wide R
Subwoofer 1
Subwoofer 2
Subwoofer 3
[Selectable items]
XLR
q GROUND
w HOT
e COLD
XLR (INV)
q GROUND
w COLD
e HOT
POA 1/POA 2
Set POA-A1HD for which the MODE select switch is set to “1” or “2”.
LINK Check
Check CONTROL LINK.
n Input Selector
Select the setup channel.
[Selectable items]
L1
R1
L2
R2
L3
R3
L4
R4
L5
R5
Select the connector input to be used for each channel.
[Selectable items]
RCA
XLR
OFF
See the POA-A1HD operating instructions.
n Power Amp
Select the setup channel.
[Selectable items]
L1/L2
L3/L4
L5/R5
R1/R2
R3/R4
Set the power amp usage for each channel.
[Selectable items]
NORMAL
BI-AMP
BRIDGE (BTL)