Filter
Top Products
Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpecificationsSetup
Auto Setup
Optimize settings for speakers in use.
F Menu tree F
Auto Setup
a Auto Setup
s Option
d Parameter Check
a Auto Setup
The settings are performed automatically.
GAuto Setup flowH
STEP1 Preparation vpage 14, 15
STEP2 Detection & Measurement (main)
vpage 16, 17
STEP3 Measurement (2nd – 8th) vpage 18
STEP4 Calculation vpage 18
STEP5 Check vpage 19
STEP6 Store vpage 19
Finish vpage 20
STEP1 Preparation
• Configure the following settings as required.
• To start Auto Setup without configuring the following settings,
perform step 4 only, and then proceed to step 2.
n Amp Assign
AVC-A1HD
Select the method for using the power amplifier in accordance with
the connected speaker configuration.
Choose this when “Amp Assign” in the GUI menu is set to anything
other than “Normal”.
n Pre-out Assign
AVP-A1HD
Change the pre-out terminal assignment.
n XLR Out Polarity
AVP-A1HD
Set to switch the XLR pre-out terminal polarity.
n Channel Select
AVC-A1HD
AVP-A1HD
The measurement time can be shortened by selecting the speakers
to be measured in advance. Please set if necessary.
When measuring 2 or 3 subwoofers, configure the “Channel
Select” settings.
• “Front Height” is displayed when the “Amp Assign” – “Assign Mode”
setting (vpage 28) in the GUI menu and the “Extension Channel”
setting (vpage 28, 29) are set to “Front Height”.
• “Front Wide” is displayed when the “Amp Assign” – “Assign Mode”
setting (vpage 28) in the GUI menu and the “Extension Channel”
setting (vpage 28, 29) are set to “Front Wide”.