Filter
Top Products
Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpecificationsSetup
ENTER
n Adjusting the subwoofer volume level
The optimum subwoofer volume level is 75 dB.
During “Measuring the subwoofer volume level” (vpage 16),
an error message is displayed when one level of subwoofers is
outside the 72 to 78 dB range.
When using a subwoofer with built-in amplifier (active type), adjust
the subwoofer volume so that the subwoofer level is within the 72
to 78 dB range.
When 2 or 3 subwoofers are used, adjust the volume level of each
subwoofer so that their volume level will set between 72~78 dB.
1
Select “SW Level Matching” and then press ENTER.
AUTO SETUP
1 2 3 4 5 6
RETURN
Skip
SW Level Matching
The subwoofer's level is too high or low. Please select "SW
Level Matching" and adjust the level of your subwoofer unit.
If you do not want to use the
subwoofer, select "Skip".
Proceed to subwoofer volume adjustment item
Enter Cancel
Caution!
2
Select “SW Test Start” and then press ENTER.
Measure the subwoofer volume level.
During measuring, a “Testing…” message is displayed.
When measurements are completed, the measurement level
value is displayed.
AUTO SETUP
1 2 3 4 5 6
RETURN
Next
dB
SW Test Start
SW Level Matching
Please place the microphone at ear height at main
listening position, then push ENTER.
Start measurement. Output test tone from subwoofer
Enter Cancel
3
Adjust the subwoofer volume level of your subwoofer
so that the level display is within the range of 72 to
78 dB.
AUTO SETUP
1 2 3 4 5 6
99.8dB
Stop
SW Level Matching
Please adjust the level of your active subwoofer unit
so that the level indicates approx. 75dB
Change from red to blue when level matches
Enter
b If the measured level is outside the 72 to 78 dB range, the level
indicator is red.
b When measuring stops, press ENTER.
AUTO SETUP
1 2 3 4 5 6
75.5dB
Stop
SW Level Matching
Please adjust the level of your active subwoofer unit
so that the level indicates approx. 75dB
Change from red to blue when level matches
Enter
b If the measured level is within the 72 to 78 dB range, the level
indicator is blue.
4
When the measured level is within the 72 to 78 dB
range, press ENTER.
5
Select “Next” and then press ENTER.
Proceed to step 2 of “STEP2 Detection & Measurement
(main)“(vpage 16).
AUTO SETUP
1 2 3 4 5 6
RETURN
Next
dB
SW Test Start
SW Level Matching
After adjustment, push "Next".
Proceed to next measurement
Enter Cancel
ENTER
(Main remote control unit) (Sub remote control unit)
ENTER