Filter
Top Products
Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpecificationsSetup
1
Set up the subwoofer
If using a subwoofer capable of the following adjustments, set
up the subwoofer as shown below.
n When using a subwoofer with a direct mode
Set the direct mode to “On” and disable the volume adjustment
and crossover frequency setting.
n When using a subwoofer without a direct mode
Make the following settings:
• Volume : “12 o’clock position”
• Crossover frequency : “Maximum/Highest Frequency”
• Low pass filter : “Off”
• Standby mode : “Off”
Before starting Auto Setup
2
Set up the microphone
Mount the setup microphone on a tripod or stand and
place it in the main listening position.
When placing the setup microphone, adjust the height of the
sound receptor to the level of the listener’s ear.
When starting Auto Setup, always use the supplied
setup microphone (DM-A409).
Correct measurements cannot be taken if the setup
microphone from the prior upgrade (DM-A505Z) is
used.
Sound receptor
Setup microphone
If you do not have a tripod or stand, set up the microphone on, for
example, a seat without a back.
NOTE
• Do not hold the setup microphone in your hand during
measurements.
• Avoid placing the setup microphone close to a seat back or wall as
sound reflections may give inaccurate results.
3
Connect the setup microphone
Connect the setup microphone to the SETUP MIC
jack of this unit.
When placing the setup microphone, adjust the height of the
sound receptor to the level of the listener’s ear.
AUTO SETUP
1 2 3 4 5 6
Amp Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual.
Set the following items
if necessary.
Start Auto Setup
Enter Cancel
When the setup microphone is connected, the
setup screen is displayed.
AUTO SETUP
1 2 3 4 5 6
XLR Out Polarity
Pre-out Assign
RETURN
Auto Setup Start
Channel Select
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in the manual.
Set the following items
if necessary.
Start Auto Setup
Enter Cancel
GSetup screen
AVC-A1HD
H
GSetup screen
AVP-A1HD
H