Filter
Top Products
480R Remote Controller
®
76
Section 8
DriveRack
™
Parameter Knobs
The parameter knobs of the 480R allow the user to edit parameters of selected effects of the
selected DriveRack™. The parameter knobs also provide the user different modes of function-
ality including: coarse/fine encoding and horizontal and vertical navigation, which allows the
parameter buttons (when used in program mode) to navigate the program screen horizontally
and vertically.
Network Access Keypad
This 12 button keypad is used to call up any one of the products that are used in a DriveRack™
network set up. Simply enter in the Id number of the device you wish to call up, and then hit
the ENTER button. This allows the user to instantly control all functions of the selected unit.
Channel Select Buttons
Instantly recalls the input channel EQ settings of the attached DriveRack™.
Output Mutes
The eight output mute buttons are used for independent output muting on all eight outputs of
the 480R DriveRack™.
System Mute Button
The SYSTEM mute button (when pressed and lit) is used to mute all eight outputs of the select-
ed DriveRack™ unit. To activate system mute, press and hold for several seconds.
Hot Key Instant Access buttons
The 32 Hot Key buttons can be assigned to instantly access any program screen of any editing
page of any unit used in the DriveRack™ network. Up to 64 different instant access assign-
ments can be made. To assign a Hot Key instant access button to a selected page, navigate to
the screen page that you wish to assign, and then press and hold the desired Hot Key until the
screen flashes. To store over any assigned Hot Key, simply repeat the procedure. Once a hot
key has been assigned, the user does not need recall or remember the individual DriveRack™
ID number. A hot key cannot however be assigned to a parameter inside the 480R itself.
Motorized Faders
The 31 motorized faders of the 480R make editing and recalling EQ settings a breeze. The 31
faders control the graphic EQ of the currently selected channel of the selected DriveRack™.
IEC Power Cord Receptacle
The 480P comes with a IEC power supply cord and a selectable power supply.
8.3 Rear Panel Connections (480P)
DriveRack™ User Manual