Filter
Top Products
Network Functions
®
66
SECTION 7
DriveRack
™
• Use the PARAMETER 2 knob to set the Target ID. This simply means that you are asking
the 480 DriveRack™ to call up the device ID of any one of the other DriveRack™ units that
are in the network system.
• Once you have called up the desired device, press the PARAMETER 3 knob to activate
the device link.
• Once the PARAMETER 3 knob is pressed, the unit will return to program mode. Repeat
this procedure anytime you wish to call up another device in the Network system.
via the
480 R DriveRack™ The procedure for calling up and controlling slave units using the 480R
Remote Controller is quite simple.
• From Program mode, use the keypad on the front panel of the 480R to enter in the
unique device ID number of the unit that you wish to control, and then simply hit the
ENTER button as shown in the illustration below.
• Once the slave unit has been called up, the 480R will control all functionality of the
selected slave unit until a new unit has been selected.
7.3 Master/Slave Assignments cont’d
DriveRack™ User Manual