Filter
Top Products
Configuring the DriveRack™
®
30
Section 3
DriveRack
™
• Now use the PARAMETER 3 knob to move the crossover module to the desired posi-
tion.
• Once the desired position has been selected, use the PARAMETER 1 knob to select the
desired crossover type.
• To change the crossover output route, press the PARAMETER 1 knob until the display
reads: 1 MODE:Route XOVER. Proceed to rotate the PARAMETER 1 knob until the
desired route is selected. Successive presses of the PARAMETER 1 knob will toggle
between select fx and route Xover
• Repeat this procedure to add additional and output route crossovers.
Once changes have been made to the current Configuration, changes can be saved by pressing
the NEXT PG button and the display will appear like this:
If you are satisfied with your Configuration changes, press the PARAMETER 1 knob. If you
wish to abort, press the PREV PG button and the DriveRack™ will return to Configuration
mode. Note that if you press the PARAMETER 1 knob to apply the changes, the DriveRack™
will return to Program mode. You will still need to save the program changes before you move
to the next program
3.8 Saving Configuration Changes
DriveRack™ User Manual