Filter
Top Products
Configuring the DriveRack™
®
26
Section 3
DriveRack
™
User Configuration creation is an ideal feature available in the DriveRack™ line. Even with the
versatility of the Factory configurations within the DriveRack™, there may be an application that
requires a a unique “custom” program. The DriveRack™ gives you the ability to create a cus-
tom routing configuration by selecting and modifying the modules including: Inputs (naming),
pre-crossover EQ, Notch Filter, Crossovers and Output Naming. The procedure for this process
is as follows.
• From Program mode, press and hold the PROGRAM/CONFIG button until the top left side
of the display reads:
CONFIGURATION
MODE: Select FX
• At this point, you can navigate the signal route to move to the module that you wish to edit
by using the PARAMETER 2 knob to move the cursor left and right and use the
PARAMETER 3 knob to move the cursor up and down.
• Once you have reached the module that you wish to edit and the module has been high light-
ed, simply use the PARAMETER 1 knob to select the various options for the selected mod-
ule. The following illustration and sub sections offer information about each section of the
signal path within the DriveRack™ unit.
3.5- A Input Routing
From the Configuration creation mode, the DriveRack™ gives you the option of routing any
physical analog input to any digital input. This means that a connection can be made at any
one of the four inputs on the rear panel of the unit and then routed to any one of the four
digital input sections within the unit. This routing feature will also allow you to number the
3.5 Creating a User Configuration
DriveRack™ User Manual