Filter
Top Products
Detailed Parameters
®
DriveRack™ User Manual
42
Section 4
DriveRack
™
The output section 480, 481 and 482 DriveRack™ units provide the user with the ability to con-
trol output levels of the unit and adjust phase compensation of loudspeakers within the signal
path. The parameters for the Phase Compensation effect are as follows and are user adjustable.
Please refer to section A.9 of the Appendix for a complete output signal routing diagram.
Level/Shift On/Off
This parameter is used to turn the selected output level and shift parameters on or off. When
level/shift is off, level is set to 0dB and phase is 0
0
.
Level Inf, -9.5 to 20.0dB
This parameter is used to set the overall output level of the selected output.
Phase Off, 0 to -360
0
Sets the amount of phase within the selected output path. The phase is referenced to the upper
frequency of the selected output crossover band. Pressing the PARAMETER 3 knob will invert
the phase of the entire band, giving an additional 180 degrees of phase.
4.9 Output Routing