Filter
Top Products
Digital Audio Processor with Room Control Crestron C2N-DAP8RC
28 • Digital Audio Processor with Room Control: C2N-DAP8RC Operations Guide - DOC. 8187A
10. Refer to “Parametric Equalizers” on page 39 adjust the frequency response
interaction within the room for each speaker in the system.
DAT Program Procedures
After launching DAT, either open an existing program for the C2N-DAP8RC, or
start a new program and choose the C2N-DAP8RC template. The following
paragraphs describe the features and functions of the DAT program. Use the DAT
software to perform the setup procedures for the C2N-DAP8RC in the order
specified in the previous section.
Toolbar Icons
The following paragraphs describe some of the unique toolbar icons that provide
quick access to important digital audio tools functions.
Realtime Mode
The Digital Audio Tools Realtime Mode permits all changes to be transferred to the
device immediately. This is especially useful during calibration of the room
To select Realtime Mode, click the Realtime Mode icon on the Digital Audio Tools
toolbar, or select Tools | Realtime Mode. The system displays the following
message:
As suggested in the message, synchronize the application and the device by
performing a “Send To Device” or “Load From Device” transfer from the
Communications tab screen before attempting any real-time equalizer configuration
changes. Refer to “Communications” on page 31 for additional details.
Source/Noise Steering
The Digital Audio Tools program “Source/Noise Steering” window is for selecting
internal noise and external audio sources for calibrating the other parameters in the
system. Refer to “Using Source/Noise Steering for Calibration” on page 30. The
option is only available if you are working in Realtime mode. Clicking the
Source/Noise Steering icon displays the screen shown on the next page.