Filter
Top Products
Listening to “Preset” Stations
1) Select tuner and either FM or AM.
2) Press the appropriate preset button (or shift + the preset button for choices higher
than “preset 7”).
4.3 Room 2 Operation
Introduction
The GTP-760’s “Room 2” circuitry gives you the ability to simultaneously enjoy two different audio/video
sources in two different areas of your home. For instance, you can watch a DVD movie in the main
family room while someone else enjoys a satellite broadcast or CD in the bedroom.
Operating “Room 2” From the Front Panel
The room 2 button on the front panel of the GTP-760 performs three separate functions:
Room 2 power ON; Room 2 status; and Room 2 power OFF.
1) To turn Room 2 power ON, press the room 2 button
once
. The LED in the center of the
room 2 button will light to tell you that “room 2” capability is on.
2) Once Room 2 is active, press the room 2 button again to display Room 2 status. The LED’s
in the center of the six front panel analog source selectors will light to show you that you can
route any of those sources to the GTP-760’s “Room 2” outputs. If one of the six source LED’s
blinks, that source is already selected for room 2 distribution.
(Note: You cannot direct a digital
source — DVD, digital 1, or digital 2 — to the Room 2 outputs.)
Choose the source you wish to direct to the room 2 outputs by pushing one of the lighted
source selectors. The LED’s in the other source selectors will go out and the name of the
source you’ve just chosen for room 2 distribution will briefly appear in the information display
window. After five (5) seconds, the display will change to show the room 1 (main) source but
the room 2 LED will still glow, indicating that a room 2 source is now active.
You can verify the room 2 source selection any time “room 2” capability is active (i.e., any time
the room 2 LED is illuminated) by simply pressing the room 2 button again. You’ll see all six
analog source selector LED’s light. The active room 2 source LED will blink and the name of
that source will show in the information display. You’ll have ten (10) seconds to change the
room 2 source by simply pressing any other illuminated source selector.
3) To power Room 2 OFF, press and hold the room 2 button until the red LED at the center of
the button goes out (about 5 seconds time).
Setting “Room 2” Playback Volume
You can change “room 2” volume only by using the remote control. There is no way to adjust “room 2”
playback level from the GTP-760’s front panel alone.
1) Press the remote control’s main source selector once. This makes sure the remote is ready to
generate GTP-760 command codes.
2) Press the room 2 button
twice
to access the room 2 status mode.
3) Use the remote control’s volume up/down buttons within ten (10) seconds of pressing
room 2. The front panel display will show room 2 level changes as you make them and will
then revert to normal display mode ten (10) seconds after the GTP-760 receives the last
volume adjust command.
37