Filter
Top Products
Video Aux Input:
This input is electrically identical to the LD input described above and will accommodate a wide
variety of audio/video sources.
After selecting and connecting the source’s composite or S-Video output to the GTP-760’s
corresponding “video aux” video input, connect the source’s left channel analog audio output to
the white RCA jack under the “video aux in” label. Then connect the source’s right channel
analog audio output to the red RCA jack under the “video aux in” label.
Room 2 Outputs:
These outputs supply video and audio
signals for distribution to a secondary
area or room in your home. Room 2
features are covered in section 4.3 of
this manual.
Connect the composite Room 2 video
output to the video display device (TV
or video projector) in the remote area.
Make sure the cable(s) you use for this
connection are high quality and well
shielded as long cable runs act as
antennas for unwanted interference signals.
(Depending on the distance between the GTP-760 and the display device and, to a lesser
extent, the video format you’ve chosen, you may need a video distribution amplifier to make
sure the signal arrives at the display device properly. Consult your ADCOM dealer for
additional information if needed.)
Connect the white “Room 2 out” jack to the left channel input of the amplifier used to power
speakers in the remote area. Then connect the red “Room 2 out” jack to the amplifier’s right
channel input.
Video Processor Inputs and Outputs:
These connections allow easy interface with video processors. Note that a separate video
processor handles video signals only so you don’t need to concern yourself with any audio
connections between it and the GTP-760. ( For additional information, consult your video
processor’s manual )
Connect the processor’s composite video output to the GTP-760’s
yellow-center “Video Processor in” jack. Then connect the video
processor’s composite input to the GTP-760’s yellow-center “Video
Processor out” jack.
If you are using the GTP-760 with a separate video processor, make
sure you’ve set the Video Processor switch to the “ON” position.
in in in in out in out
digital 2 digital 1 LD
room2
out
video processor
in out
standard monitor
12
IR repeater
L
R
rearfrontCDoutin
tape
out
VCR video aux room2
video processor
in out
14