Filter
Top Products
29 AC Convenience Outlets (115VAC models)
These outlets are for low-current source components only. They are not
designed for power amplifiers.
The single unswitched outlet is live whenever the GTP-760 is plugged into a live AC source. The two
switched outlets are live only when the GTP-760 is fully operational (i.e., whenever the front power
button’s LED is red.) They are not live when the GTP-760 is in standby mode (when the LED is yellow.)
Observe the wattage limitations printed above the two switched and one unswitched outlets. Note that
the 500VA figure (equivalent to 500 watts) above the two switched outlets is a maximum figure for both
outlets combined. Do not exceed this limit.
We strongly recommend the use of our surge suppresser/ line conditioners, the ADCOM ACE family of
products, for systems with substantial amplifiers and many source components. The ACE products
relieve the GTP-760 from handling large current surges, while they protect your entire system by
filtering and conditioning the AC current. In addition to the numerous heavy duty AC outlets of the
ACE-315, the ACE-615 includes sequential power-up and power-down modes to minimize “thumps”
whenever you turn your system on or off.
1.3 The Remote Control
The GTP-760 remote control is a learning remote control that is capable of saving commands for all
remote controls in your home theater system. In this way, you may eliminate the confusion of using
multiple remotes. Although such power comes with some added complexity, the complexity is minimal
and with some repetition will become second nature.
The single most important aspect to master about the GTP-760 remote control is the function of the
eight source select buttons at the top of the remote. These are buttons 30 in the figure on the next
page. Each of these buttons cause two things to happen when used. First, they select the
corresponding input on the GTP-760. Second, THESE KEYS REMAP ALL OF THE OTHER BUTTONS
ON THE REMOTE CONTROL. You can think of each of these buttons as having a page of commands
associated with it.
Most of the GTP-760 remote commands are saved under the main remote page. Whenever you desire
to control the GTP-760 via remote, you must first ensure the main page is active. As an example,
press main on the remote control. Now, press the dim button. If your GTP-760 is on, the brightness of
the front panel display changes. Notice also that the main button on your remote illuminates. This
serves as a reminder that the main remote page is currently active.
Now press the CD button and then the select/play button. Notice now that the CD source button lights.
The CD remote page is now active. If you have an ADCOM CD player, this command will cause an idle
CD to play. Now, press the dim button again. You should note that CD button does not light. The dim
command is not preprogrammed in the CD remote page. If your GTP-760 is on you will also notice the
display does not respond to this command. Press the main button again to reenter the main remote
page. The dim button will now again change the GTP-760 display.
The button description that follows distinguishes the function of each button dependent on the page the
remote is in. The remote is shipped from the factory with ADCOM commands saved under the main,
tuner and CD pages.
The ADCOM universal remote controller is preset to operate most GTP-760 functions (MAIN
device mode), GTP-760 AM/FM tuner functions (TUNER device mode) and GCD-700/750 CD
functions (CD device mode).
19