Filter
Top Products
BUTTON FUNCTION
Main CD Tuner All Others
0
Not programmable
Track 10
Programmable Programmable
+ 10
Not programmable
+ 10
Programmable Programmable
SHIFT
Not programmable
Call Presets 8 - 14
Programmable
FM/AM
Not programmable
Repeat FM or AM select
Programmable
STEREO Stereo mode select Program/Mem. Stereo/Mono
Programmable
SRND Surround mode select Random play
Programmable Programmable
ENTER
Not programmable
Time display Seek/Manual
Programmable
D. RANGE Dynamic range adjust Disc 1
Programmable Programmable
REAR + Rear level up Disc 2
Programmable Programmable
CENTER + Center level up Disc 3
Programmable Programmable
SUB + Subwoofer level up Disc 4
Programmable Programmable
BAL. CHK Balance check Disc 5/Memory clear
Programmable Programmable
DIALOG Dialog enhance on/off A-B repeat
Programmable Programmable
REAR - Rear level down Clear repeat
Programmable Programmable
CENTER - Center level down
Programmable Programmable Programmable
SUB - Subwoofer level down
Programmable Programmable Programmable
DIM Dim display
Programmable
Dim Display
Programmable
M1 For Macro use For Macro use For Macro use For Macro use
M2 For Macro use For Macro use For Macro use For Macro use
M3 For Macro use For Macro use For Macro use For Macro use
M4 For Macro use For Macro use For Macro use For Macro use
ROOM 2 Room 2 source select
Programmable Programmable Programmable
MUTE Mute volume Mute volume Mute volume
Programmable
PROGRAMMING YOUR ADCOM GTP-760 REMOTE CONTROLLER
Introduction
The ADCOM universal remote controller operates eight different audio/video components. As you’ve already
seen, it’s preprogrammed to control ADCOM’s GTP-760 Preamp/Tuner and the GCD-700 CD player. In addition,
it has five “component memory banks” available so you can program the remote to learn commands for your
DVD player, satellite box, laserdisc player, VCR, etc. This lets you use one remote controller for your
entire system.
Using Preprogrammed Commands
Using the remote controller’s preprogrammed commands is simple. For most GTP-760 functions (volume up/
down, changing surround modes, etc.), follow these easy steps.
1. Press the main source selector button. This tells the remote that you want to use GTP-760
preprogrammed commands. The main button will flash red to tell you it understands.
2. Press the appropriate function button (volume up, volume down, etc..) If you’ve selected a button
that actually triggers a GTP-760 command, the main button will again flash red to confirm your choice.
If the main button does not flash, you’ve selected a function button that isn’t preprogrammed.
(Review the table above to see which buttons are preprogrammed.)
25