Filter
Top Products
For tuner functions (changing stations, etc.):
1. Press the tuner source selector button. It will flash red.
2. Press the tuning up (or tuning down) function button to change stations. The tuner source selector
will flash red to confirm that the function button you’ve selected actually triggers a command. (Again,
use the table to see which buttons are preprogrammed.)
Press the CD source selector first to access preprogrammed commands for ADCOM CD players.
NOTE:
You can program new commands over the preprogrammed commands in tuner and CD if you wish.
However, you cannot program any buttons, even those unprogrammed with GTP-760 command codes, while
you’re in main mode. This safety feature assures you that you will always be able to fully enjoy the
GTP-760’s capabilities.
Programming Your Own Commands
You can supplement preprogrammed commands with commands to operate other components. Before you
begin to follow these steps, note the status LED located at the top left corner just above the remote’s button
panel: It will flash red, orange, or green to signal particular functions as you enter new commands into your
ADCOM remote.
Begin by deciding which source component’s commands you will be transferring to the ADCOM remote. Then
press the appropriate source selector button. For example, if you’re teaching your ADCOM remote commands
for your DVD player, press the DVD source selector first. You can “teach” your remote new commands for any
function button (
except
backlight) after you’ve selected DVD, VCR, TUNER, V.AUX, CD, Dig.1 or Dig.2.
1. Place the source component’s remote “head to head” with the ADCOM remote. They should be in line
with each other about 2 to 3 inches apart.
2. Press the ADCOM remote’s appropriate source selector and select/play buttons simultaneously. Hold
both buttons until the status LED turns orange and the source selector button glows red. Both indica
tors should remain lit.
3. Decide which function button on the ADCOM remote you want to learn a new command. Press it. The
orange status LED will begin to flash and the source selector LED will go out.
4. Find the corresponding button on the source component’s remote. Press and hold it until the status
LED on the ADCOM remote flashes green once and remains green until the button on the source
remote is released. Once the button on the source remote is released, the status LED will start
flashing orange again.
5. Verify that the ADCOM remote has learned the new command by pressing and holding the same button
on the source remote. The ADCOM remote’s status LED should flash green twice and then go back to
steady orange. This indicates successful programming. Release the button on the source remote.
Repeat Steps 3 through 5 for any other commands you want to teach your ADCOM remote
for that source component.
Save the commands you’ve just programmed into the ADCOM remote by pressing and holding the appropriate
source selector and select/play buttons simultaneously. Hold until the status LED and source selector LED
flash twice and then go out. Repeat these steps for any other source commands you wish to program.
26