Overview
November 6 2014 – Revision 2.1
Page 8 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
CAUTION
To reduce the risks associated with environmental contamination due to
battery pack & to lead in the solder:
• Dispose of batteries, power supplies, battery charger and base
station in accordance with federal, state & local requirements. If
preferred, return these components to 3M Service Center for recycle.
Other Conventions
Important Notes and Notes
Important Note:
It is strongly recommended that you pay attention to information inside of an
“Important Note:” box.
Note:
You may find information inside of a “Note:” box helpful.
FCC and Industry Canada Information
Important Note:
FCC RF Exposure Statement:
3M™ Wireless Communication System, Model XT-1 and the 3M™ Drive
Thru Headset G5 comply with FCC RF radiation exposure limits set forth for
an uncontrolled environment when operating based on time-averaged output
power with duty cycle not to exceed 7.63% with a separation distance of
25mm. The wireless system must not be co-located or operating in
conjunction with any other antenna or transmitter.
• Use the power supply indoors and in dry locations only.
To reduce the risks associated fire, explosion & property damage:
• Do not open, crush, or expose to heat above 55 °C/130 °F. For
additional charging and use instruction refer to operators manual
• The battery used in this device may present a risk of fire or chemical
burn if mistreated. Do not disassemble, heat above 55 C/130 F, or
incinerate. Replace model XT-1 battery with Lithium-Ion battery 3M
78- 6911-4721-5 only. Replace model G5 battery with Lithium-Ion
battery 3M 78-8117-4656-5 only. Use of another battery may present
a risk of fire or explosion. Keep away from children. Do not
disassemble and do not dispose of in fire.
• Always replace batteries, battery chargers and power supplies with
3M approved units acceptable for use in this system to avoid system
function & safety concerns.
• The 3M™ Drive-thru Headset Battery Charger, G5 12-slot and the
3M™ Drive-Thru Headset Charging Station, G5 are supplied with two
power connections to allow for connecting an additional charger
and/or base station. During installation, do not connect more than
one power supply to one charger, or to the interconnected string of
chargers.
• Do not modify this 3M™ Wireless Communication System Model XT-
1, or 3M™ Drive Thru Headset G5. Install only 3M provided
components. Use only 3M approved system replacement parts.