Filter
Top Products
Appendix: Greeter Module
November 6 2014 – Revision 2.1
Page 68 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
2.
Change the value of the playback setting. Your choices are:
•
YES
- A tone will play in the headsets while the greeting
message plays to the customer at the order point.
•
NO
- No tone will play in the headsets.
Turn on Restaurant Closed Playback Message
You can assign a standard message to be played to customers during hours when
the restaurant is closed. The clock and store hours must be set correctly, and the
actual message must be recorded as Type CLOSED, then it can be set to activate
automatically whenever the restaurant is closed.
To select which restaurant closed playback message is chosen:
1.
Navigate to
Restaurant Closed Playback Message
.
2.
Change the value of the playback setting. Your choices are:
•
OFF
- The factory provided “Store Closed” message is used.
•
ON
- The custom recorded CLOSED message is used.
Note:
The main setting for enabling the “Store Closed” message is located in the
System Menu>Global Settings>"Store Is Now Closed"
menu.
:GREETER MESSAGE PROPERTIES:
External Detector Playback Message>OFF<
Greeter Revision <03>
Turn on External Detector Playback Message
If an external detector is used and connected to the EXT_MSG trigger pin on the
base station circuit board, you can assign a message to be played back whenever
the external detector is activated.
To turn on the external detector playback message:
1.
Navigate to
External Detector Playback Message
.
2.
Change the value of the playback setting. Your choices are:
•
OFF
- The external input will not trigger a message in “Original
Mode”.
•
<001>through<016>
- Selecting a message number means
the corresponding message will play when the external detector
is activated, in “Original Mode”.
Note:
The external inputs previously used for mode selection and external message
trigger now have a dual purpose. In “Original Mode”, they can still be used
for their original purpose. The input can also be set to an ALERT message
number and will trigger the Alert Message playback when activated.
Greeter Revision
The hardware revision of the Greeter Module is listed.