Filter
Top Products
Maintenance
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
November 6 2014 – Revision 2.1
Page 49 of 77
Refitting the headset with the new Carrier
Use the steps outlined in
Assembling a G5 Headset
under the
Operations
section of this document
Replacing the Ear and Headband Pads
To replace the ear pad, remove the worn/damaged ear pad from the ear cup and
replace it with a new pad.
To replace the headband pad, remove the worn/damaged headband pad from the
end of the headband and replace it with a new pad.
G5 Headset Charger
Location
The G5 headset charger can be placed flat on an even surface or mounted on a
wall, being parallel or perpendicular to the ground as shown in illustration
below. Make sure the surface is clean and is in a dry environment.
NOTE
: Mounting hardware is not provided with the Headset Charger.