Filter
Top Products
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
March 2014 –Revision 2.0
Page 63 of 77
Appendix: Greeter Module
Greeter Setup
The Greeter Module is an accessory used to record messages and play them
back, either when a vehicle arrives (GREETER, CLOSED, FORWARD), when
an event occurs, such as a door opening (ALERT), or periodically on a schedule
(REMINDER).
The Greeter Module has enough memory to store 64 seconds of audio, broken
into sixteen 4 second messages. The message types available are:
GREETER – Each Greeter message takes up two 4 second message slots for a
total of 8 seconds. Greeter messages are restricted to ODD message numbers
(i.e. 001, 003, 005, 007, 009, 011, 013, and 015). There can be a maximum of 8
Greeter messages.
REMINDER – Each Reminder message takes up one 4 second message slot for
a total of 4 seconds. Reminder messages can be recorded in any of the 16
message slots, allowing for a maximum of 16 Reminder messages.
ALERT – Each Alert message takes up one 4 second message slot for a total of
4 seconds. Alert messages can be recorded in any of the 16 message slots,
allowing for a maximum of 16 Alert messages. However, the system has 4 Alert
Message Input Triggers, so only 4 Alert messages can be used at any one time.
CLOSED – The custom “Store Closed” message follows all the rules of a
Greeter Message.
FORWARD – The custom Tandem Lane “Pull Forward” message follows all
the rules of a Greeter Message.
Note:
For a Dual Lane system, some message types are not available. The message
Types available on each base station are as follows:
Lane 1 = GREETER, REMINDER, ALERT and CLOSED
Lane 2 = GREETER, CLOSED and FORWARD
Enter the Greeter Configuration Menu
All of the greeter module settings are located in the “Greeter Menu”
configuration menu.
Perform the following procedure to enter the greeter configuration menu:
1.
Enter the base station configuration mode, see page 11.
2.
Press and release
Mode
until the
Greeter Menu
appears.
The following menu choices are available.
a)
Message Activation
b) Record Messages
c) Choose Headsets Messages Playback To
d) Message Daypart Definitions
e) Greeter Message Properties
f) Alert & Reminder Message Properties
g) Alert Message External Trigger Input