3M G5 Headphones User Manual


 
Operation
November 6 2014 – Revision 2.1
Page 44 of 77
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
Base Station Setup
Most of the base station configuration is performed during installation by the
installer or by a manager. The setup options listed in this section are only those
that can be performed without entering the passcode-protected areas of the base
station.
The following procedures are all performed at the base station using the base
station keypad. The base station must be turned on (plugged in) and in Run
Mode without a security passcode entered.
The following diagram shows how the display on the base station looks in Run
Mode.
Figure 5
Navigating in the Base Station in Run Mode
To navigate the base station in Run mode you only need to use
Enter
,
Mode
, and
the directional arrow buttons: up
, down
, left
, and right
. The
remaining buttons function only in manager or installer configuration modes.
Change Order Taking Mode
There are seven order taking modes, which offer different combinations of
speaking, listening, automatic standby, vehicle detector, and order point modes.
Perform the following procedure to switch to a different order taker mode:
1.
Press
until the
Mode
selection is highlighted.
2.
Press
Enter
.
3.
Press
,
,
, or
to select a new order taker mode. Your choices
are
ML/PTT
,
ML/MLT
,
AL/PTT
,
AL/MLT
,
Hands Free
,
Outside
, and
Always On
. See “Explanation of Order Taking Modes,” and “Which
Order Taking Mode to Select” below.
13:25 WED,NOV/16/2005 | MODE< ML/PTT >
NOISE REDUCTION [LOW] | LANE 2 <SPLIT>
GREETER PLAYING MSG 1 | VOLUME < DAY >