Filter
Top Products
Appendix: Greeter Module
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
November 6 2014 – Revision 2.1
Page 69 of 77
V2 Greeter Modules require XT-1 base station software version 3.00 or later to
function properly.
V3 Greeter Modules require XT-1 base station software version 4.00 or later to
function properly.
Alert & Reminder Message Properties
The Alert & Reminder Message Properties menu is a collection of settings
affecting the message types ALERT and REMINDER.
1.
Enter the greeter configuration menu.
2.
Select
6 Alert & Reminder Message Properties
.
:ALERT & REMINDER MESSAGE PROPERTIES:
Msg.>011< [Reminder 1 ] [REMINDER]
Priority:<N> Delay:<00:00> Count:< 1>
Repeat:<00:01:00> Monitor:<OFF>
3.
Using the
,
,
⊳
,
and
Enter
keys, select a message number and
configure the settings. Your choices are:
•
Priority
•
<Y>
- means the message will enter a queue if the
scheduled play time occurs during an active order. The
message will play when the current vehicle departs or the
call is dropped by the order taker.
•
<N>
- means the message will be skipped and not play if
the scheduled play time occurs during an active order.
•
Delay
•
<mm:ss>
- Upon the start of a new day part, the playback
of the first message will be delayed by this setting,
entered in minutes and seconds. If the delay places the
message start time into an active order, the message is
skipped or placed into queue. If the delay places the
message outside an active daypart, the message is
skipped.
•
Count
•
<XXX>
- Count is the number of the times the message is
scheduled to be played during the current active daypart.
•
Repeat
<hh:mm:ss>
- The repeat time, entered in
hours:minutes:seconds, is the amount of time elapsed
before the next scheduled message plays, with the elapsed
time starting when the previous message finishes
•
Monitor
•
<OFF>
- The selected message is not played to the grill
monitor speaker.
•
<ON >
- The selected message is played to the grill
monitor speaker, if one is installed.
Alert Message External Trigger Inputs
Perform the following procedure to select the function for each of four
external inputs: