Filter
Top Products
Configuration
3M™ Drive-Thru Systems Model G5 and Model XT-1
Operating Instructions
November 6 2014 – Revision 2.1
Page 11 of 77
Configuration
Enter Configuration Mode
Configuration mode is a passcode-protected area that contains most of the
configuration options for the base station system. Using the access provided for
users it is possible to set up all of the functionality of the system.
For basestations with software version 4.0 or 5.12 and higher.
To enter the configuration mode:
• From the Run mode menu, press
Mode
.
• Enter your user passcode.
• Press
Mode again
. The display will show the user name and ID number
(e.g.,
User1 ID = 1
)
For basestations with software version 2.29 or 3.14 or 3.42.
To enter the configuration mode:
• From the Run mode menu, press and hold
Mode
.
• While continuing to hold
Mode
, enter your user passcode.
• Release
Mode
. The display will show the user name and ID number
(e.g.,
User1 ID = 1
)
Notes:
The default user password is 1234.
There are two levels of passcode: installers and users. Using a user’s
passcode permits you into the entire system menu.
Navigating the Base Station Display
Once you are in the configuration mode, you can use the buttons on the base
station display to update all configuration parameters.