Quick Start
This section’s instructions are based on the assumption that your new system is pre-
configured and requires only accessory installation (e.g. antenna and/or barcode scanner) and
a power source.
Use this guide as you would any other source book -- reading portions to learn about the VX6,
and then referring to it when you need more information about a particular subject. This guide
takes you through installation and operation of the LXE VX6.
In general, the sequence of events is:
1. Install Vehicle Mounting Bracket on vehicle and secure VX6 in Mounting Bracket
Assembly (see “Installation”, later in this manual).
2. Connect power cable to the VX6. The power cable can also be connected to a UPS
battery pack, which is then connected to the VX6.
3. Connect accessories to VX6, e.g. scanner, antenna, etc.
4. Secure all cables to the VX6 with the Strain Relief Cable Clamps.
5. Turn the VX6 on.
6. When instructed, calibrate the touchscreen.
7. The screen may appear white while applications and drivers are loading. When
complete, set Date and Time (see the “VX6 Reference Guide”).
8. Configure wireless client (see the VX6 Reference Guide”).
9. Warmboot to ensure all registry settings are saved.
Device is ready for use.
The VX6 should be mounted in an area in the vehicle where it:
•
Does not obstruct the vehicle driver’s vision or safe vehicle operation.
•
Can be easily accessed by anyone seated in the driver’s seat.
Note:
If your VX6 has AppLock installed, please contact your system administrator for setup
and processing information. AppLock is configured by an administrator to limit general
users to only certain programs.
