Remote Vehicle Mount Antenna
The external antenna (or antennas) can be remotely mounted on the vehicle. Please refer to
the “Vehicle Remote Mount Antenna Installation Sheet” for details.
Internal Antenna
If the internal antenna option is ordered, an antenna is mounted on the inside of the user
access panel cover.
The internal antenna assembly has two antenna cables. Attach the antenna cables to the
wireless client card. When this process is complete, reattach the access cover screws using a
torque wrench capable of measuring to 9±1 inch pounds force (1.016±.11 N m). The screws
must be fastened to 9 inch pounds each. The screws require a Phillips size 1 driver head.
Connect Serial Barcode Scanner
Refer to the documentation received with the barcode scanner for complete instructions. Read
all warnings and caution labels.
Note: Before using the scanner, read section titled “Operation”, sub- section titled “Laser
Barcode Scanner Warnings”.
Pin 9 of COM1 is configured to provide +5V. To change Pin 9 of the port, please refer to
Chapter 4, “System Configuration” in the “VX6 Reference Guide”.
The scanner cable is attached to the connector labeled “COM1/SCANNER”. The scanner
receives power from the VX6.
The cable requires a nine-pin D-shell female connector for the VX6.
Note: Use of a shielded cable is required to maintain FCC and CISPR22 emissions compliance.
1. Power off the VX6 before connecting the scanner cable to the VX6.
2. Seat the connector firmly over the pins and turn the thumbscrews in a clockwise direction. Do
not overtighten.
3. Use a strain relief clamp to secure the cable.
4. Press the power button to power up the VX6.
