Step 3 - Attach VX6 Assembly To Bottom Mounting Bracket.
1. Place lock washer first, then flat washer on 1/4-20x5/8 bolt. Next insert mounting bolts
through the curved apertures in the bottom mounting bracket and into the screw holes on
the side of the back mounting bracket.
2. Loosely tighten each bolt as it is inserted.
Important: Do not torque bolts until all bolts are in place and viewing angle is
adjusted.
3. Loosen the hex bolts on both sides to adjust the viewing angle of the mounted VX6.
4. Torque the hex bolts to 50±5 in lbf (5.64±.56 N m).
Note: Test the torque on the bolts frequently during operation and re-tighten if
necessary to 50±5 in lbf (5.64±.56 N m).
6. If using a UPS battery pack, the battery pack can be mounted to the bottom mounting
bracket. Place a locking washer and then a flat washer on a 1/4-20x2 bolt. Thread the bolt
through the UPS Battery Pack, then through the 1” aluminum spacer and into the mounting
bracket.
7. Connect all cables to the VX6. Secure the cables with the strain relief cable clamps, ensuring
a slack loop remains between the cable clamp and the accessory connector.
8. The vehicle mounted bracket and the VX6 are now ready to use.
Install Stylus Tether and Sleeve
The LXE stylus kit includes the stylus, tether and sleeves. The tether allows the stylus to be
mounted to the VX6 and the sleeve provides storage for the stylus when not in use.
How To Install Stylus Tether and Sleeves
Locate the tether holes on the top of the VX6. (see below):
Select the mounting hole most convenient for the particular VX6 installation.
Slide the clip end of the stylus tether into the tether mounting hole.
Determine a convenient location for the stylus sleeve. Apply the adhesive baked Velcro
®
loop
strip to the VX6. Attach the Velcro
®
hook strip on the elastic stylus sleeve to the loop strip.
