Procedure
Step 1a – Mount Vehicle RAM Ball Base
Note: If you are using the RAM clamp mount, please skip to Step 1b.
1. Determine the position for mounting the RAM ball base. Be sure to position the RAM ball base
to allow access to the switches and ports on the bottom of the VX6.
2. Attach the RAM ball base to the vehicle mounting surface using four 1/4 bolts (or equivalent)
fasteners.
Note: .......1/4 Bolts not included.
IMPORTANT: Mount to the most rigid surface available.
Step 1b – Mount Vehicle RAM Clamp Mount
Note: If you are using the RAM ball base, complete Step 1a and skip Step 1b.
1. Determine the position for mounting the RAM clamp mount. The clamp mount can be used
on a beam (such as on a fork lift truck) up to 2.5” (63.5 mm) wide and approximately 2”
(50.8 mm) thick. The clamp may be attached to a thicker beam by substituting longer bolts
(not included). Be sure to position the RAM clamp mount to allow access to the switches and
ports on the bottom of the VX6.
2. Position the upper clamp piece with ball (A) on the beam. Place the bolts (B) through the
holes in the upper clamp piece.
3. Position the lower clamp piece (C) below the beam. Align the bolts with the holes in the
lower clamp piece.
4. Place the nylon locking nuts (D) on the bolts and tighten the bolts.
