UPS Battery Pack Remote Mount
The optional UPS battery pack must be mounted remotely when using the RAM mount system
or a U-bracket designed for a previous model LXE computer. The remote mount can also be
used with the VX6 U-bracket assembly if it is not convenient to mount the UPS battery pack to
the U-bracket.
A six foot extension cable is available to connect the UPS battery pack to the VX6.
1
.
Position the UPS battery pack to allow cables to reach the vehicle battery and the VX6.
2
.
Attach the UPS battery pack to the vehicle mounting surface using two 1/4 bolts, lock
washers and flat washers (or equivalent) fasteners.
Note:1/4 Bolts and washers not included.
IMPORTANT: Mount to the most rigid surface available.
Connect Antenna
Several antenna options are available for the VX6. Options include single or dual external
antennas, remote vehicle mount antennas and an internal antenna.
External Antenna
Note: VX6’s are equipped with a wireless device and require an antenna. Some VX6’s may be
equipped with a dual antenna option. For these VX6’s, an external antenna must be
connected to each antenna connector.
Place the antenna over the antenna connector. Push down and twist clockwise until the
antenna is secured. Repeat for second antenna connector, if present.
Adjust the antenna angle to improve RF communications with the computer network.
Note: Substitution of antennas is not permitted unless authorized by LXE. Use of unauthorized
antennas will void the FCC emissions certification of the VX6.
