Central Management 99
Change Ethernet Half or Full Duplex Mode
To set the Ethernet duplex mode on:
■ one line
■ all lines
■ VCN APs
■ line cards in the VCN AC
■ VCN APs and the lines cards in the VCN AC
1
Ty p e
4 in the
Management Agent Menu
(Figure 64) and press <Enter>;
the
Concentrator Configuration Menu
(Figure 77
) appears.
2
Ty p e
2 and press <Enter> ; the following dialog appears:
Which cards would you want to change?
Select: 1 - to change Line Cards only,
2 - to change Access Points only,
0 - for both:
3
Type your selection and press <Enter>.
The system requests which line cards or VCN APs you want to change:
Enter port number (1 - 24, 0 for all): 1
4
Enter a port number in the range 1 - 24 or select all by entering 0; the
following dialog then appears:
Enter F - for full duplex,
H - for half duplex:
5
Ty p e
f
or
h
and press <Enter>.
The system confirms the change you selected with the statement that
starts:
You are going to change the Ethernet mode
and completes the statement with the AP or AC port(s) you selected and
the mode you selected. Then the statement appears:
Do you want to proceed (Y/[N])? :
6
To
■ confirm type y and press <Enter>; the statement appears:
Action has been done.
■
cancel type
n
and press <Enter>; the statement appears:
Action has been canceled.
