104 M
ANAGING
THE
VCN A
CCESS
C
ONCENTRATOR
■
To discard changes and keep current settings, type
n
and press
<Enter>.
Reset Agent
To reset the Management Agent, type
5
in the
Agent Configuration
Menu
(Figure 78
) and press <Enter>.
The message appears:
This action will reset the agent
Do you want to proceed (Y/[N])? : y
To re je ct , ty pe
n
and press <Enter>; the message appears:
The action has been canceled
Press ENTER to continue
To proceed, type y and press <Enter>; the message appears:
The system is going down..
Performing
Agent Reset
terminates a Telnet management session that
may be in progress. The Telnet user will not receive a warning.
The
Operation Mode Selector
menu appears (Figure 75
). This is followed
by the messages in Figure 54
and Figure 55 and the
Login
prompt.
Central Management
Via Telnet
This section describes central management of an VCN AC through a
remote connection using the Telnet protocol.
Overview
The remote management interface utilizes the standard Telnet remote
terminal emulation protocol.
Only one management session is permitted at a time. The user of central
management through the LMA can close a remote Telnet session to
enforce this limit.
The management station cannot Telnet through a VCN AP to the VCN
AC.
