Line Card Management 71
After any number the user enters, the message appears:
Action has been done.
The first line in the
LC Configuration Menu
confirms the user VLAN ID
entry.
Set Ethernet Half/Full Duplex Mode
To set the Ethernet duplex mode:
1
In the
Line Card Main Menu
, type
7 and press <Enter>.
2
In the
LC Configuration Menu, type
2 and press <Enter>.
The dialog appears:
Enter ’f’ for full duplex or ’h’ for half duplex [f]:
■ To establish Ethernet full duplex mode, type f and press <Enter>.
■ To establish Ethernet full duplex mode, type h and press <Enter>.
After either entry, the message appears:
Action has been done.
The second line of the LC Configuration Menu (Figure 45) provides
confirmation.
Change Password
To change the LC password:
1
In the
Line Card Main Menu
, type
7 and press <Enter>.
2
In the
LC Configuration Menu, type
3 and press <Enter>. The message
appears:
Enter the old password:
3
Respond by entering your current password. The message appears:
Enter the new password (up to 8 characters): *****
4
Respond by entering your new password. The message appears:
Confirm new password (up to 8 characters): *****
The message appears:
The password was changed and saved in a non-volatile memory
