Central Management 103
To close the Telnet session, type y and press <Enter>.
The message appears:
The action has been done
A message regarding session close does not appear on the Telnet screen.
To cancel session close, type
n and press <Enter>.
The message appears:
The action has been canceled
The default is n.
Set Factory Defaults
To restore the user password and network parameters to the factory
defaults, type
4 in the
Agent Configuration Menu
(Figure 78) and press
<Enter>.
The messages appear:
This action will return the system parameters to their
default values
Do you want to proceed (Y/[N])? :
Confirm or discard the change:
■
To c o nf ir m,
a
Ty p e
y and press <Enter>.
The messages appear (Figure 80
):
Figure 80 Factory Defaults are Set
b
To use the changes, reset the card (refer to Reset Port
for Line Card 1)
or the management agent (refer to Reset Agent
).
The factory’s default settings were written to the
non-volatile memory
Note: some of the changes will take effect just after reset
Press ENTER to continue ...
