Yamaha DVR-S200 Stereo System User Manual


 
55
Creating the Best Listening Space
Creating the Best Listening Space
English
One speaker weighs about 1.0 kg (2.2 lb). Make sure you fasten screws only into a solid wall or pillar. Do not attach to a wall
that is made of plaster, decorative veneer sheeting or other material that peels easily. If the screws come off and a speaker falls,
somebody may get injured.
Do not attach the speakers using nails or two-sided tape. Vibration during use may cause the nails to loosen, tape to peel off and
speakers to fall, resulting in injury.
CinemaStation may fall over if your feet or hands get caught in the speaker cable. Make sure the cables are fixed in place.
After attaching everything, check the overall safety of your installation.
YAMAHA will bear no responsibility for accidents caused by improperly placed equipment or faulty installation methods.
Placing the Front and Surround Speakers
Attach to the wall using the two holes on the back of the Front and
Surround Speakers.
Attach 2 screws (3.5 to 4 mm dia., commercially
available) to each place you want to hang a Front
or Surround Speaker.
Hang the speakers on the screws using the
holes in the back of each speaker.
Make sure that the tapping screw enters the narrow part of the hole
and the speaker is fixed securely in place.
As shown in the picture, attach the non-skid pads on the bottoms
of the Front and Surround Speakers in the four corners. This
stabilizes the speakers to prevent sliding.
* Place on a stable, flat surface.
You can place the Front Speakers and Surround Speakers
on the floor or a rack, or attach them to a wall. You can also
mount them on commercially available speaker stands.
Note
Notes
Non-skid pad
Screws (3.5 to 4 mm dia.,
commercially available)
110 mm
10 mm
20 mm or
more
When placing on the floor or a rack
When attaching to a wall
110 mm
012DVX-S200-en 04.3.1, 11:18 AM55