Filter
Top Products
52
Using Other Equipment
• Perform a test recording before recording.
• It is not possible to record DSP effects.
• CinemaStation cannot output a Super Audio CD signal to the
OPTICAL OUT jack. To record a Super Audio CD signal,
connect external devices (such as CD or MD recorder) to the
analog output jacks and use it to record the signal.
• When you turn off the connected CD recorder or MD recorder
power, playback sound may become distorted and the volume
reduced. In this case, turn on the CD recorder or MD recorder
power.
• Even if you adjust the audio volume, audio quality, or change
the DSP Program during a video recording, it has no effect on
the recorded sound. However, in DVD/CD mode, the output
sound for recording may cut off if any of the operations below
are performed. Do not perform any of the below during
recording.
— Output a test tone.
— Change a DSP Program
— Connect/disconnect the headphones
• CinemaStation can output a signal from the DIGITAL IN jack
to the DIGITAL OUT jack. The signal input from the
DIGITAL IN jack cannot output from the analog output jacks,
and the signal input from the analog input jacks cannot output
from the DIGITAL OUT jacks.
• Do not use audio recordings that you make for any purpose
other than private enjoyment without the consent of the
copyright holder.
Timer Playback/Recording
Combined with a commercially available audio timer, you can
perform Timer Playback and Timer Recordings.
Operations vary depending on the equipment and audio timer
used, so be sure to read the relevant equipment owner’s manual.
Notes on recording and playing audio
011DVX-S200-en 04.3.1, 11:17 AM52