Filter
Top Products
98
Appendix
No sound except from the Front
Speakers.
1 You are listening to STEREO sound.
Press STEREO and make sure sound field
effect is on.
2 You are playing a source such as Dolby
Surround, Dolby Digital or DTS that doesn’t
contain a special effect signal.
Select another DSP Program.
3 A digital audio sampling frequency over 48
kHz is input.
A digital audio sampling frequency over 48
kHz only outputs from the Front Speakers.
No sound from the Center Speaker.
1 You turned off the Center Speaker volume
level.
Turn up the Center Speaker volume. See
page 61.
2 You set “* CENTER” in the SET MENU to
“NON”.
Set the Center Speaker correctly. See page
64.
3 You have selected a DSP Program from the
Music group (excluding 5ch Stereo).
Select another DSP Program. See pages 16
and 17.
4 Dolby Digital and DTS sources do not
contain a center channel signal.
No sound from the Surround Speakers.
1 You turned off the Surround Speaker
volume level.
Turn up the Surround Speaker volume. See
page 61.
2 CinemaStation plays a monaural source in
the Theater DSP Program.
Select another DSP Program. See pages 16
and 17.
No sound from the Subwoofer.
1 You set “* BASS” in the SET MENU to
“FRONT” when CinemaStation plays a
Dolby Digital or DTS source.
Set “* BASS” to “SWFR” or “BOTH”. See
page 64.
2 You set “* BASS” in the SET MENU to
“FRONT” or “SWFR” when CinemaStation
plays a 2-channel source.
Set “* BASS” to “BOTH”. See page 64.
3 The source doesn’t contain an LFE or other
low tone signal (below 90 Hz).
No low tones.
The Speaker mode you selected in the SET
MENU does not match your speaker.
Set the appropriate Speaker mode based on
the size of the speakers you are using. See
page 63.
Strange humming noises.
You did not connect the pin cable properly.
Check your pin cable connections.
Cause
Solution
Cause
Solution
Cause
Cause
Solution
Cause
Solution
Cause
Solution
Cause
Cause
Solution
Cause
Solution
Cause
Solution
Cause
Solution
Cause
Cause
Solution
Cause
Solution
019DVX-S200-en 04.3.1, 11:23 AM98