Yamaha RX-V2700 Stereo Receiver User Manual


 
RECORDING
83 En
BASIC
OPERATION
Recording adjustments and other operations are performed from the recording components. Refer to the operating
instructions for those components.
The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in
noise being recorded. Therefore, if you want to use this unit to record sources encoded in DTS, the
following considerations and adjustments need to be made. To play DTS-encoded DVDs and CDs
(when using a digital audio connection) on your DTS-compatible player, follow its operating
instructions to make a setting so that the analog signal will be output from the player.
When this unit is set to the standby mode, you cannot record between other components connected to this unit.
The settings of TONE CONTROL (see page 52), VOLUME, the speaker level (see page 109) and the sound field programs (see
page 47) do not affect recorded material.
The source connected to the MULTI CH INPUT jacks of this unit cannot be recorded.
The XM Satellite Radio signals (U.S.A. and Canada models only) cannot be output at the AUDIO OUT (REC) jacks.
Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (REC) jacks for recording. Likewise,
analog signals input at the AUDIO IN jacks are not output at the DIGITAL OUTPUT jack. Therefore, if your source component is
connected to provide only digital or analog signals, you can only record digital or analog signals.
A given input source is not output on the same OUT (REC) channel.
S-video and composite video signals pass independently through the video circuits of this unit. Therefore, when recording or dubbing
video signals input from a video source component that provides only an S-video or a composite video signal, you can record only an
S-video or a composite video signal on your VCR.
The analog audio signals input at the DOCK terminal can be output at the analog AUDIO OUT (REC) jacks for recording.
Check the copyright laws in your country to record from CDs, radio, etc. Recording of copyrighted material may infringe copyright
laws.
y
Do a test recording before you start an actual recording.
1 Turn on all the connected components.
2 Press REC OUT/ZONE 2 repeatedly until the
RECOUT indicator lights up in the front panel
display.
3 Rotate the PROGRAM selector on the front
panel to select the source component you
want to record from.
Select “SOURCE” to record the currently selected
input source.
4 Start playback on the selected source
component or select a broadcast station.
5 Start recording on the recording component.
RECORDING
Notes
If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture
itself may be disturbed due to those signals.
CAUTION
ON/OFF
MASTER
PURE DIRECT
VOLUME
MAIN ZONE
INPUT
ON
OFF
ENHANCER
NIGHT
ZONE ON/OFF
ZONE CONTROLS
MODE
TUNING
PRESET/TUNING
EDIT
MULTI ZONE
FM/AM
PRESET/
TUNING
MAN'L/AUTO FM
MEMORY
MIC
OPTIMIZER
EFFECT
STRAIGHT
CONTROL
SELECT
AUDIO
TONE
REC OUT/
ZONE2
A/B/C/D/E
PROGRAM
YPAO
ZONE 3
R
L
OPTICAL
USB
ZONE 2
AUDIO
VIDEO AUX
SILENT CINEMA
S VIDEO
VIDEO
PHONES
23
(U.S.A. model)
REC OUT/
ZONE2
RECOUT
PROGRAM
Front panel