Yamaha RX-V2700 Stereo Receiver User Manual


 
22 En
CONNECTIONS
Audio signal flow
2-channel as well as multi-channel PCM, Dolby Digital and
DTS signals input at the HDMI IN 1, HDMI IN 2 or HDMI IN
3 jack can be output at the HDMI OUT jack only when
“Support Audio” is set to “Other” (see page 115).
Audio signals input at the HDMI IN jacks are not output at the
analog AUDIO OUT and DIGITAL OUTPUT jacks.
Video signal flow
When the analog video signals are input at the COMPONENT
VIDEO, S VIDEO and VIDEO jacks, the priority order of the
input signals is as follows:
1. COMPONENT VIDEO
2. S VIDEO
3. VIDEO
The analog video signals output at the COMPONENT VIDEO
jacks can be deinterlaced from 480i (NTSC)/576i (PAL) to
480p/576p. Set “Component I/P” to “On” in “Video” to activate
this feature (see page 102).
Digital video signals input at the HDMI IN 1, HDMI IN 2 or HDMI IN
3 jack cannot be output to analog video output jacks.
The analog component video signals with 480i (NTSC)/576i
(PAL) of resolution are converted to the s-video or composite
video signals and output at the S VIDEO MONITOR OUT and
VIDEO MONITOR OUT jacks.
Component interlace/progressive conversion (see page 102) and
HDMI up-scaling (see page 102) are available only when
“Conversion” is set to “On” (see page 102).
Use the “HDMI Up-Scaling” parameter in “Video” to
deinterlace and convert the resolution of the analog video
signals output at the HDMI OUT jack (see page 102).
The GUI screen signal is not output at the VCR 1 OUT and
DVR/VCR 2 OUT jacks and is not recorded.
Audio and video signal flow
Notes
DIGITAL AUDIO
(OPTICAL)
DIGITAL AUDIO
(COAXIAL)
HDMI
AUDIO
OutputInput
Analog output
Digital output
Notes
S VIDEO
VIDEO
COMPONENT
VIDEO
HDMI
Through
Output
HDMI interlace/progressive
up-conversion and resolution up-
scaling (see page 102)
Component interlace/progressive
up-conversion (see page 102)
Input
Video conversion (see page 102)