Yamaha RX-V2700 Stereo Receiver User Manual


 
23 En
CONNECTIONS
PREPARATION
Connect your TV (or projector) to the HDMI OUT jack, the COMPONENT VIDEO MONITOR OUT jacks, the S
VIDEO MONITOR OUT jack or the VIDEO MONITOR OUT jack of this unit.
Do not connect this unit or other components to the AC power supply until all connections between
components are complete.
y
You can select to play back HDMI audio signals on this unit or on another HDMI component connected to the HDMI OUT jack on the
rear panel of this unit. Use the “Support Audio” parameter in “Option” to select the component to play back HDMI audio signals (see
page 115).
Some video monitors connected to this unit via a DVI connection fail to recognize the HDMI audio/video signals being input if they
are in the standby mode. In this case, the HDMI indicator flashes irregularly.
Set “Conversion” in “Video” to “On” (see page 102) to display the short message displays.
Set “Wall Paper” in “Video” to “Yes” or “Gray” (see page 104) to display the parameter displays.
The GUI screen appears with the wall paper or gray background depending on the input video signal format and the setting of the
parameters in “Wall Paper” (see page 104).
Connecting a TV monitor or projector
Notes
CAUTION
VIDEO
S VIDEO
MONITOR OUT
COMPONENT VIDEO
HDMI
MONITOR OUT
Y
PR
P
B
OUT
PRPB
V
S
Y
TV
(or projector)
(U.S.A. model)
Video in
Component video in
S-video in
HDMI in
indicates recommended connections
indicates alternative connections