Yamaha RX-V2700 Stereo Receiver User Manual


 
53 En
USING AUDIO FEATURES
BASIC
OPERATION
You can adjust the output level of each speaker while
listening to a music source. This is also possible when
playing sources input at the MULTI CH INPUT jacks.
This operation will override the level adjustments made in “Auto
Setup” (see page 35) and “Speaker Level” (see page 109).
1 Set the operation mode selector to AMP and
then press LEVEL on the remote control
repeatedly to select the speaker you want to
adjust.
y
Once you press LEVEL on the remote control, you can
also select the speaker by pressing k / n.
Instead of “SB R” and “SB L”, “SB” is displayed if
“Surround Back” is set to either “Small x1” or “Large x1”
(see page 106).
2 Press l / h on the remote control to adjust
the speaker output level.
Press h to increase the value.
Press l to decrease the value.
Control range: –10 dB to +10 dB
You can mix down multi-channel sources to 2 channels
and enjoy playback in 2-channel stereo.
Set the operation mode to AMP and then press
STEREO on the remote control repeatedly to
select “2ch Stereo”.
y
You can use a subwoofer with this program when “Bass Out” is
set to “SWFR” or “Both” (see page 107).
You can also select the “2ch Stereo” mode by rotating the
PROGRAM selector on the front panel.
You can also select the “2ch Stereo” mode and adjust the
parameter by using GUI screen. See page 88 for details.
Adjusting the speaker level
Note
Display Adjusted speaker
FRONT L
Front left speaker
CENTER
Center speaker
FRONT R
Front right speaker
SUR. R
Surround right speaker
SB L
Surround back right speaker
SB R
Surround back left speaker
SUR. L
Surround left speaker
SWFR
Subwoofer
PRNS L
Presence left speaker
PRNS R
Presence right speaker
TITLE
BAND
LEVEL
TV
SOURCE
AMP
A/B/C/D/E
PRESET/CH
ENTER
Enjoying multi-channel sources in
2-channel stereo
5
STEREO
2ch Stereo
TV
SOURCE
AMP